Impact of hydrocolloid and foaming agent on the physicochemical, microstructural and bioactive characteristics of foam-mat freeze-dried tapai (fermented black glutinous rice) powder.

The aim of this study was to obtain fermented black glutinous rice (FBGR) powder using the foam-mat freeze-drying method and to evaluate the physicochemical, microstructural, and bioactive characteristics of FBGR powder. To obtain FBGR foams, maltodextrin (MD; 0%-40% w/w) and whey protein isolate (WPI; 7.5% w/w) were used. The results showed that MD concentration had a significant effect (p ≤ .05) on powder recovery and bulk density which increased from 68.9% to 80.5% and 0.46% to 0.63 g/ml, respectively. The lowest moisture content (2.17%) and water activity (0.48) were found in powders produced with 20% MD. The solubility of FBGR powders ranged from 74% to 75% and increasing MD concentration gave higher lightness (L*) and yellowness (b*) readings in color properties of powders. Although the addition of the carrier agent caused reductions in total phenolic content and anthocyanins, the retention of these bioactive compounds rose with increasing MD content from 67% to 76% and 78% to 84%, respectively. FBGR produced with 40% MD had the most superior physical and technological properties, and foam-mat freeze-drying is a promising technology for retaining the bioactive compounds in FBGR.

Comparison of blueberry powder produced via foam-mat freeze-drying versus spray-drying: evaluation of foam and powder properties.

BACKGROUND: Blueberry juice powder was developed via foam-mat freeze-drying (FMFD) and spray-drying (SD) via addition of maltodextrin (MD) and whey protein isolate (WPI) at weight ratios of MD/WPI = 0.4 to 3.2 (with a fixed solids content of 5 wt% for FMFD and 10 wt% for SD). Feed rates of 180 and 360 mL h-1 were tested in SD. The objective was to evaluate the effect of the drying methods and carrier agents on the physical properties of the corresponding blueberry powders and reconstituted products. RESULTS: Ratios of MD/WPI = 0.4, 1.0 and 1.6 produced highly stable foams most suitable for FMFD. FMFD gave high yields and low bulk density powders with flake-like particles of large size that were also dark purple with high red values. SD gave low powder recoveries. The powders had higher bulk density and faster rehydration times, consisting of smooth, spherical and smaller particles than in FMFD powders. The SD powders were bright purple but less red than FMFD powders. Solubility was greater than 95% for both FMFD and SD powders. CONCLUSION: The FMFD method is a feasible method of producing blueberry juice powder and gives products retaining more characteristics of the original juice than SD. © 2017 Society of Chemical Industry.